Description
The DKS 9000 series of slide gate operators offer convenience, reliability and safe operation in a small, compact design. These operators are ideally used in residential, commercial or industrial high-use applications. The steel frame and belt drive/gear-box reduction system provide a powerful, yet extremely quiet, slide gate operation. The 9000 uses an advanced microprocessor control circuit with outstanding features. Designed with versatility in mind, these operators will fit most slide gate operation requirements.
Features
- Adjustable Partial Open: Allows long gates to open 14 ft (4.2 m) for automobile traffic, or opens gate fully for large trucks or oversized vans
- Entrapment Prevention: Reverses gate when obstructed to prevent injury and damage
- Precise Limit Control: Simple setup to customize gate limits for any property
- Easy Access: Built-in power switch and alarm reset switch
- Belt Drive: Steel frame and belt drive / gear-box reduction system provide a powerful, yet extremely quiet gate operation
Specifications
- Maximum gate width 35-ft.
- Maximum gate weight 1000 pounds* (1/2 HP) or 1500 pounds* (1 HP). (*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
- 1/2 or 1 HP continuous-duty motor
- 115, 230*, 208*, 460* VAC. (*230, 208, and 460 volt units use a step-down power transformer to achieve 115 volt operating voltage.)
- Class I, II, III and IV applications
- Direct driven limit nuts for precise gate control
- Auto-close timer 1-30 seconds
- Selectable loop / reverse input function; stop or reverse Anti-tailgating feature helps to control un-authorized traffic
- Standard normally closed stop circuit
- Ports for plug-in open and reverse loop detectors (DKS detectors only)
- Two 115 VAC convenience outlets for accessory transformers
- Compliant with UL 325 and 991, ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, additional Type B1 and/or Type B2 entrapment protection devices are required to be installed with this gate operator.
